Camera.withLatLong constructor

Camera.withLatLong({
  1. required double latitude,
  2. required double longitude,
  3. required double altitude,
  4. required double heading,
  5. required double pitch,
  6. required double roll,
})

Creates a camera with the specified latitude, longitude, altitude, heading, pitch, and roll.

Parameters:

  • latitude — The latitude of the camera position in degrees.
  • longitude — The longitude of the camera position in degrees.
  • altitude — The altitude of the camera position in meters. If the altitude is below the ArcGISScene.baseSurface and the Surface.navigationConstraint is set to NavigationConstraint.stayAbove, the camera will be located at the Surface. Note: that the default is NavigationConstraint.stayAbove.
  • heading — The angle around the z-axis the camera is rotated. The angle is clockwise from north in the East, North, Up (ENU) ground reference frame. The value is between 0 to 360. 0 is looking North and 90 is looking East. Values are wrapped around so that they fall within 0 to 360.
  • pitch — The angle around the y-axis the camera is rotated in the East, North, Up (ENU) ground reference frame. The value is between 0 to 180. 0 is looking straight down and 180 is looking straight up. A negative value defaults to 0 and a value greater than 180 defaults to 180. If the behavior of a negative pitch is required, then the corresponding transformation with positive pitch can be set instead. For example, if heading:0 pitch:-20 roll:0 is required then heading:180 pitch:20 roll:180 can be used instead.
  • roll — The angle around the x-axis the camera is rotated in the East, North, Up (ENU) ground reference frame. The value is between 0 to 360. 0 is horizontal, 180 is upside down. Values are wrapped so that they fall within 0 to 360.