Sets the offset distance, type and other parameters for the GeometryService.offset operation.
See the properties for a list of all the properties that may be passed into the constructor.
The name of the class.more details
The array of geometries to be offset.more details
Specifies the distance for constructing an offset based on the input geometries.more details
Options that determine how the ends intersect.more details
The offset distance unit.more details
bevelRatiois multiplied by the offset distance and the result determines how far a mitered offset intersection can be located before it is beveled. When mitered is specified, the value set for
bevelRatiois ignored and
10is used internally. If beveled is specified,
1.1will be used if no value is set for bevelRatio. The bevelRatio is ignored when
The name of the class. The declared class name is formatted as
The array of geometries to be offset.
Specifies the distance for constructing an offset based on the input geometries. If the
offsetDistanceparameter is positive, the constructed offset will be on the right side of the curve. Left side offsets are constructed with negative values.
Options that determine how the ends intersect. Set to one of the following options:
Possible Value Description bevelled Squares off the corner after a given ratio distance. mitered Attempts to allow extended offsets to naturally intersect. If the intersection occurs too far from a corner, the corner will be beveled off at a fixed distance. rounded Rounds the corner between extended offsets.
Possible Values: feet | kilometers | meters | miles | nautical-miles | yards
Converts an instance of this class to its ArcGIS Portal JSON representation.more details